Table of Contents
Advertisement
UPS Installation Plan and Unpacking
3.3
Inspecting and Unpacking the UPS Cabinets
The cabinet is shipped bolted to a wooden pallet and protected with an outer wood container.
The UPS cabinet is heavy (see Table 3-1). If unpacking and unloading instructions are not closely
followed, the cabinet may tip and cause serious injury.
1.
Carefully inspect the outer packaging for evidence of damage during transit.
Do not install a damaged cabinet. Report any damage to the carrier and contact an
Eaton service representative immediately.
2.
Use a forklift or pallet jack to move the packaged cabinet to the installation site, or as close as possible,
before unpacking. If possible, move the cabinets using the pallet. Insert the forklift or pallet jack forks
between the supports on the bottom of the pallet (see Figure 3-6 through Figure 3-10 for the UPS cabinet
centre of gravity measurements).
Do not tilt the UPS cabinets more than 10° from vertical or the cabinets may tip over.
3.
Set the pallet on a firm, level surface, allowing a minimum clearance of 3m (10 ft) on each side for
removing the cabinet from the pallet.
4.
Remove the inner protective packaging. Retain the ramp brackets.
5.
Recycle the remainder of the outer shipping container and the inner protective packaging in a responsible
manner.
6.
Inspect the contents for any evidence of physical damage, and compare each item with the Bill of Lading.
If damage has occurred or shortages are evident, contact an Eaton service representative immediately to
determine the extent of the damage and its impact on further installation.
3-22
Eaton 93E UPS (15-80 kVA, 380/400/415V) Installation and Operation Manual
For the following step, verify that the forklift or pallet jack is rated to handle the weight of
NOTE
the cabinet (see Table 3-1 for cabinet weight).
WARNING
CAUTION
CAUTION
Advertisement
Table of Contents
