Table of Contents
Advertisement
3 3
Inspecting and unpacking the uPS Cabinets
The cabinet is shipped bolted to a wooden pallet and protected with an outer wood container.
The UPS cabinet is heavy (see Table 3-1). If unpacking and unloading instructions are not closely
followed, the cabinet may tip and cause serious injury.
1.
Carefully inspect the outer packaging for evidence of damage during transit.
Do not install a damaged cabinet. Report any damage to the carrier and contact an
Eaton service representative immediately.
2.
Use a forklift or pallet jack to move the packaged cabinet to the installation site, or as close as possible,
before unpacking. If possible, move the cabinets using the pallet. Insert the forklift or pallet jack forks
between the supports on the bottom of the pallet (see Figure 3-3 and Figure 3-4 for the UPS cabinet
centre of gravity measurements).
Do not tilt the UPS cabinets more than 10° from vertical or the cabinets may tip over.
3.
Set the pallet on a firm, level surface, allowing a minimum clearance of 3m (10 ft) on each side for
removing the cabinet from the pallet.
4.
Remove the protective wood container from the cabinet:
a.
b.
c.
d.
e.
f.
5.
Remove the inner protective packaging. Retain the parts kit box, ramp brackets, and ramp extension
packed at the top of the cabinet.
6.
Recycle the remainder of the outer shipping container and the inner protective packaging in a responsible
manner.
20
Eaton 9EHD UPS (20-40 kVA, 380/400/415V) Installation and Operation Manual
For the following step, verify that the forklift or pallet jack is rated to handle the weight of
NOTE
the cabinet (see Table 3-1 for cabinet weight).
For the following steps, use pincer type pliers or a large flat blade screw driver to
NOTE
straighten the securing tabs.
Straighten the tabs securing the top panel of the wooden container to the side panels of the
container.
Remove the top panel and retain for later use as a ramp in unloading the cabinet from the pallet.
Straighten the tabs securing the side panels of the container to the front and back panels of the
container.
Remove the side panels.
Straighten the tabs securing the front and back panels of the container to the bottom of the container.
Remove the front and back panels.
WARNING
CAUTION
CAUTION
Advertisement
Table of Contents
