Hammond Skx PRO Reference Manual page 716

Using Memory
696
6. Use the DIRECTION " " button to move the cursor to the next box down. It may say PATCH
or CUSTOM depending on the type of file you are Loading.
NOTE: The Tone Wheel option will have an additional box, DB TYPE, which will allow you to
select which Drawbar Organ Type to Load the Custom Tone Wheel from. For more information
consult the CUSTOM SETS chapter of this Guide.
7. Use the DIRECTION " " button to move the cursor to TO and use the VALUE knob to select
the location from which to Load the selected file.
NOTE: The Setup option will not have the TO box. If you are Loading a Setup, skip Step 7.
NOTE: If the TO location displays Empty, there is no File to Load.
8. When you have finished the Naming procedure, press the ENTER button to complete the
Loading procedure. You will see the following messages flash in the display for approximately
1 second each:
When the above message disappears, your file has been Loaded.
HA<O>
SKX PRO Reference Guide