Connecting a Leslie Speaker The 11-pin Leslie socket on your SK PRO allows you to plug directly into any Leslie speaker having an 11- pin interface. If you wish to use a Leslie Speaker with your SK PRO, the Leslie Speaker should be connected before turning the power "ON."...
Page 3
Introduction NOTE: The 11-pin Leslie socket on your SK PRO allows you to plug directly into any Leslie speaker having an 11-pin interface. Current models include the 2101, 3300, 122XB and 981. However, when plugging the SK PRO into a single-channel Leslie cabinet such as a 3300, only the Drawbars will sound through the Leslie.
"ON." NOTE: The SK PRO has an “AUTO POWER OFF” feature which automatically turns the power to the instrument “OFF” if no keys or controls are used within a 30-minute period. See page 8 for more information about this feature.
Page 5
Drawbars are the heart and soul of the Hammond Sound. The SK PRO has nine Drawbars, sometimes referred to as Tonebars. When the Keyboard SPLIT feature is active, these same nine Drawbars are used to control the sound registrations for both UPPER Keyboard, (left of the SPLIT Point) and LOWER KEYBOARD (right of the Split Point) as well as Pedal tones.
NOTE: The SK PRO is compliant with USB AUDIO Class 1.0, the generic device driver which comes pre-installed on both PC and Mac computers. This means you can use the USB TO HOST Port to connect the SK PRO to a computer and transmit and receive a MIDI data stream without an exclusive device driver.
Page 7
Playing the instrument Although the SK PRO is a single-keyboard instrument, it can be made to function in a manner similar to an instrument with two keyboards and a pedal keyboard, such as an organ. This is the reason for the references to UPPER, LOWER and PEDAL on the instrument.
POWER - AUTO OFF The SK PRO has a special feature called AUTO POWER OFF which automatically turns the power to the instrument “OFF” if no keys or buttons are pressed for 30 minutes. This is done for safety reasons and under most normal conditions we do not recommend disabling this feature;...
Page 9
Introduction Press the DIRECTION “ ” button once. The Information Center Display should now look like this: Press the ENTER button. The Information Center Display should now look like this: The data chart below shows the options you may select. POWER - AUTO OFF Description Function...
Page 10
*** THIS PAGE INTENTIONALLY LEFT BLANK TO PRESERVE PAGE FORMATTING ***...
Need help?
Do you have a question about the SK Pro and is the answer not in the manual?
Questions and answers