Hammond Skx PRO Reference Manual page 426

CUSTOM SETS - Tone Wheel
406
9. Press the ENTER button. The Information Center Display will look similar to this:
This is the screen you will use to Name your Custom Tone Wheel. You can use the FAVORITE
buttons and the BANK and MANUAL buttons (the two rows of six buttons just below the
Information Center Display) to select and enter characters The data chart below explains the
function of each of the buttons.
Parameter
Aa1
Delete
space FAVORITE 1
Insert FAVORITE 6
ABC, etc. FAVORITES 2 ~ 5, 7 ~ 10.
You can also turn the VALUE knob to select characters. If you wish to do this, use the
DIRECTION " " and " " buttons to move back and forth through the characters.
10. When you have finished the Naming procedure, press the ENTER button to complete the
Recording procedure. You will see the following messages flash in the display for
approximately 1 second each:
After the "Completed" message disappears, your Custom Tone Wheel has been Recorded.
HA<O>
SKX PRO Reference Guide
NAMING PARAMETERS
Button
BANK Changes the character type (Capital and lower-case letters, numbers,
special characters).
MANUAL Deletes the character at the cursor.
Replaces the character at the cursor with a space.
Inserts a space at the cursor.
Use these to cycle through and select the characters for the highlighted
location. Each successive touch will cause the next character to display -
for example, touching the Number 2 button will display A, touching it
again will display B and touching it a third time will display C.
Description