Hammond Skx PRO Reference Manual page 471

6. When you have made your selection, use the DIRECTION " " button to move the cursor to the
"RECORD" box.
7. Press the ENTER button. The Information Center Display should look similar to this:
This is the screen you will use to Name your Custom Pipe. You can use the FAVORITE buttons and
the BANK and MANUAL buttons (the two rows of six buttons just below the Information Center
Display) to select and enter characters The data chart below explains the function of each of the
buttons.
Parameter Button
Aa1 BANK
Delete MANUAL
space FAVORITE 1
Insert FAVORITE 6
ABC, etc. FAVORITES 2 ~ 5, 7 ~ 10.
You can also turn the VALUE knob to select characters. If you wish to do this, use the
DIRECTION " " and " " buttons to move back and forth through the characters.
8. When you have finished the Naming procedure, press the ENTER button to complete the
Recording procedure. You will see the following messages flash in the display for approximately
1 second each:
After the "Completed" message disappears, your Custom Pipe has been Recorded.
NAMING PARAMETERS
Changes the character type (Capital and lower-case letters, numbers,
special characters).
Deletes the character at the cursor.
Replaces the character at the cursor with a space.
Inserts a space at the cursor.
Use these to cycle through and select the characters for the highlighted
location. Each successive touch will cause the next character to display -
for example, touching the Number 2 button will display A, touching it
again will display B and touching it a third time will display C.
CUSTOM SETS - Pipe
Description
HA<O>
SKX PRO Reference Guide
451