Winding The Bobbin Thread - Bernina 790 PRO Manual

> Attach the filled bobbin on the vertical spool pin so that the silvery sensor surface is down.
> Attach the thread spool in the opposite direction to the bobbin.
> Thread the 3 threads up to the upper thread guide.
> Guide 2 threads (vertical spool pin) past the thread tension disc (1) on the left and up to the thread guide
above the needle.
> Guide 1 thread (horizontal spool pin) past the thread tension disc (1) on the right and up to the thread
guide above the needle.
> Thread 1 thread of the vertical thread spool pin into the left and right needle by hand.
> Thread the thread of the horizontal spool pin into the center needle manually.

Winding the Bobbin Thread

The bobbin thread can be wound while embroidering if the swiveling spool holder is used for winding.
• The foam pad, the thread spool and the appropriate spool cap are fitted.
> Place the empty bobbin on the winding unit (1) so that the silver sensor surfaces are facing downwards.
> Guide the thread to the left into the rear thread guide (2).
> Guide the thread around the bobbin winder pretension clockwise (3).
> Wind the thread clockwise 2 – 3 times around the empty bobbin (4).
2
3
> Pull the excess thread over the thread cutter at the engaging lever (5) and cut.
1
4
5
Sewing Preparation
47