Selecting The Stitch Plate In The User Interface; Thread-Up Command; Switching The Laser On/Off - Bernina 790 PRO Manual

Embroidery Preparation
> Press the stitch plate down at the marking at the back on the right until it tilts.
> Remove the stitch plate.
> Place the opening of the stitch plate (Straight and CutWork Stitch Plate) above the corresponding guide

Selecting the Stitch Plate in the User Interface

After changing the stitch plate, you can check whether it can be used with the selected needle.
> Tap «Stitch Plate Selection».
> Select Straight and CutWork Stitch Plate.

Thread-up Command

The machine must be ready for embroidery to bring up the bobbin thread. The bobbin thread can be
brought up in one step for a manual knotting. If no securing stitches are wanted, it is recommended to
deactivate the securing stitches in the Setup.
> Hold the upper thread.
> Push the button«Needle position Up/Down».

Switching the Laser On/Off

The laser can be used to indicate the exact needle entry point.
•
> To activate the laser, tap «Laser».
> To avoid the deflection of the laser with transparent presser feet, lower the presser foot before the
> To switch off the laser, tap the field highlighted in yellow «Laser».
140
pins and press it down until it clicks into place.
– The bobbin thread is brought up automatically.
The needle is raised.
– The entry point is displayed. Depending on the presser foot and needle position, the entry point may
be concealed by the presser foot.
sewing start, e.g. with the knee lifter.