Activating/Deactivating The Function Thread Away - Bernina 790 PRO Manual

Table of Contents

The length of the connecting thread can be set from 1 to 15 mm, the default setting is 6 mm. This

means that all connecting stitches longer than 6 mm are cut automatically. If the value is reduced to

1 mm, more thread cuts are carried out, it takes longer to embroider and more loose thread ends can be

seen on the wrong side of the fabric, especially when the function 'Thread-away' is activated too. On the

right side of the fabric there will be practically none or merely very short connecting stitches which results

in a wonderful stitch formation. Reducing the length of the thread cut to 1 mm is particularly of

advantage when embroidering texts where usually many short connecting threads occur. If both sides of

the stitch pattern are visible, it may be useful not to reduce the length of the thread cut too much to

avoid having too many loose threads on the wrong side that get stitched in place during the process of

embroidering and are then difficult to remove.

> Tap «Setup Program».

> Tap «Embroidery Settings».

> Tap «Thread Cut Settings».

> To set the length at which the connecting stitches are cut, tap «Minus» or «Plus» (1) or deactivate

automatic thread cut for connecting stitches.

> To activate/deactivate the automatic thread cut before a thread change, tap the switch in the upper

section of the display (2).

> To make the machine stop after approx. 7 stitches so that the remaining thread can be cut by hand,

touch the switch in the middle section of the display (3).