Winding The Bobbin Thread - Bernina 735 User Manual

Sewing Preparation

Winding the bobbin thread

The bobbin thread can be wound while embroidering if the swiveling spool holder is used for winding.
Prerequisite:
•
> Place the empty bobbin on the Winding Unit (1) so that the silvery sensor surface is down.
> Guide the thread to the left into the rear thread guide (2).
> Guide the thread around the bobbin winder pretension clockwise (3).
> Wind the thread clockwise 2 – 3 times around the empty bobbin (4).
> Pull the excess thread over the thread cutter at the engaging lever (5) and cut.
> Push the engaging lever (6) towards the bobbin.
> Set winding speed.
> To stop the winding process, the engaging lever must be pushed to the right.
> Push the engaging lever towards the bobbin again to continue the winding process.
> Remove the bobbin and cut the thread using the thread cutter at the engaging lever.
44
The foam pad, the thread spool and the appropriate spool disc are fitted.
2
3
– The machine winds and the display to wind the bobbin appears.
– As soon as the bobbin is full, the machine stops the winding process automatically.
1
4
5
6