Enter The Fabric Thickness; Programming The Securing Stitches; Centering Or Opening Embroidery Designs In The Original Position - Bernina 790 PRO Manual

Enter the Fabric Thickness

If the fabric thickness is more than 4 mm as for e.g. toweling, it is recommended to select 7.5 mm or 10
mm. The thicker the fabric, the slower the embroidery speed of the machine. When the machine is switched
off, the alterations are reset to the basic setting 4 mm.
> Tap «Setup Program».
> Tap «Embroidery Settings».
> Tap «Entering the Fabric Thickness».
> Select fabric thickness.

Programming the Securing Stitches

Embroidery motifs are programmed either with or without securing stitches. If an embroidery motif has
programmed securing stitches, they will be embroidered. If the embroidery motif is programmed with
securing stitches, the securing stitches can be removed in the BERNINA Embroidery Software.
The machine recognizes when no securing stitches are programmed and adds them. If no securing stitches
are wanted, they can be deactivated.
> Tap «Setup Program».
> Tap «Embroidery Settings».
> Tap «Securing Stitches».
> To deactivate the securing stitches at the start, switch off the switch in the upper section.
– If the embroidery motif doesn't have any programmed securing stitches, none are embroidered.
> Turn on the switch in the upper section to deactivate the securing stitches at the start.
– If the embroidery motif doesn't have any programmed securing stitches, the securing stitches are
added and will be embroidered.
> Turn off the switch in the lower section to deactivate the securing stitches at the end.
– If the embroidery motif doesn't have any programmed securing stitches, none are embroidered.
> Turn on the switch in the lower section to activate the securing stitches at the end.
– If the embroidery motif doesn't have any programmed securing stitches, the securing stitches are
added and will be embroidered.

Centering or Opening Embroidery Designs in the Original Position

When opening the embroidery designs on the machine, they are always centered in the Embroidery Hoop. If
it is desired to open embroidery designs in the original position (determined by the BERNINA Embroidery
Software), the function «Centering the Embroidery Design» must be activated.
> Tap «Setup Program».
> Tap «Embroidery Settings».
> Tap «Centering the Embroidery Design».
> Tap the Switch.
– A previously moved embroidery design which has been saved in the new position is opened in the
saved position after selecting.
Setup Program
57