Table of Contents
Advertisement
a) RAMP function
37
With this programming the output in the PCA-570 varies automatically, producing ramps and levels can be
programmed for actuate a once or continuously.
Must enter beginning and end values of the range within which the output will excursion (MIN and MAX),
and also the value of TIME (in seconds) desired for one complete excursion of range. Other value what can be
configurated is the duration of the level (WAIT), in other words, the time whereby remains constant between two
ramps.
After configurable the special function and activate (change the key for
press OK. For initiate the ramp, press the icon from chronometer
to the strategy defined (up, down, up/down). To stop, press STOP
b) STEP Programming
The STEP programming goes to the output from PCA-570 varies in pre-defined steps. It is useful in
calibrations where certain scale points are checked; for example 0% ⎯ 25% ⎯ 50% ⎯ 75% ⎯ 100%.
To generate the setpoint, you should defined the points minimum and maximum of range (MIN and MAX),
the percentage of output variation for each step (%), and generate the list (button
or delete manually any points of values of setpoint list (button
selected, button
If you want each step to be reached automatically after a preset time has elapsed, you must set the time in
seconds. In this situation the steps are swept automatically and uninterruptedly. By activating the function and
pressing OK, the output starts STEP programming, always starting from the beginning of the range. To go to the next
step you must press. By pressing you go to the previous step. Pressing the chronometer icon
swept automatically and uninterruptedly according to the set time. To stop, press STOP
remove all the points of the list).
in the special function) and
. The ramp is executated continuously according
.
). Also there's the option to add
add the point in the list, button
.
delete the point
, the steps are
Advertisement
Table of Contents
