4.4 After usage
1. Remove the headgear with the mask.
2. Push the on/off switch to switch the device off.
4.5 Read off therapy duration
CPAP 20e saves the data from 366 days and the associated therapy duration. You can
display the following values:
•
Total therapy duration in hours
•
Average therapy duration per day
•
Therapy duration of current day including date
Note:
A therapy day always starts and ends at 12 noon. Data recorded between midnight and
12 noon is allocated to the previous day.
The total therapy duration is shown for a few seconds when the unit is switched on. When
switching off the therapy duration for the current day is displayed.
To read off further data, proceed as follows:
The daily therapy duration of the last session is shown
on the display. Then "0" appears.
3. Remove the tube connection and the exhalation system
from the mask.
4. Clean the mask and the exhalation system(see "5.
Hygienic preparation" on page 25).
Note:
CPAP 20e and the power supply consume approx. 4
watt in standby mode .The unit does not have a mains
switch. To save electricity you can remove the power
plug from the outlet socket during the day. It is there-
fore advisable to connect the unit to a readily accessible
socket. The stored values and settings will not be lost.
5. Clean the humidifier (see "5. Hygienic preparation" on
page 25).
Operation
23