Breathing Mask - Weinmann Homecare CPAP 20e Manual

Adapting the humidifier
Locking catch

3.3 Breathing mask

Fitting the mask
1. Adjust the forehead support of the mask (if present).
2. Connect the headgear to the mask.
3. Position the mask.
4. Adjust the headgear so that the bulge of the mask only results in low pressure to prevent
pressure points on the face.
Note
For further instructions, please refer to the operating instructions for the relevant mask.
Warning!
Full-face masks must be equipped with an emergency exhalation valve so that you
can breathe through nose or mouth in the event of any device failure. Full-face masks
without an emergency exhalation valve may not be used!
External exhalation system
No exhalation system is integrated in some masks. In order for the used, carbon dioxide
(CO )-enriched air to be able to escape, an external exhalation system is required on these
2
masks. Follow the instructions for use of your exhaled air system.
18 Set up of equipment
1. If necessary, release the corrugated tubing from the
therapy unit.
2. Click the humidifier into position from the front onto
the sleep apnea unit. The inlet connection and the heat-
ing rod must be directed towards to the sleep apnea
unit. Take care to engage the lock.
3. Connect the corrugated tube to the outlet connections
of the humidifier.
4. To release the humidifier, press the locking catch and
withdraw it off the unit.