Softstart Setting; After Usage - Weinmann SOMNOcomfort 2e Description Of The Equipment And Instructions For Use

Cpap unit
Table of Contents

Advertisement

Automatic switch-off at low levels
If the therapy unit detects that there is not enough liquid in the humidifier, it switches the
humidifier off within 15 minutes. The humidifier symbol

4.4 Softstart setting

The softstart time can be selected in 5-minute increments up to a maximum of 30 minutes.
Proceed as follows:
1.
Switch on SOMNOcomfort 2e and press the softstart button
down until the display for the softstart time flashes.
2.
Now select the softstart time (5-30 minutes in 5-minute increments) using the on/off
switch (+) or the softstart button (-).
If a button is not pressed for 4 seconds, the displayed softstart time will be saved and
the display stops flashing.
The softstart settings are saved when the unit is switched off. Whenever
SOMNOcomfort 2e is started up, it automatically starts in softstart mode if this was
switched on.
Softstart can be switched on and off at any time by pressing the softstart button

4.5 After usage

1.
Remove the headgear with the mask.
2.
Press the on/off switch to switch off the unit. If the automatic system is selected, the
unit switches off automatically after approx. 15 seconds.
22
EN
Operation
The daily therapy duration of the last session is shown
on the display. Then "0" and "A" or "M" are dis-
played.
in the display goes out.
. Hold the button
.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

SomnoaquaWm 24405Wm 24455

Table of Contents