How To Put All The Zones Into Test Across A Network - EMS FirePoint 5000 Operating Manual

EMS 5000 FIREPOINT
11 Press the "∇" key once and the screen will now
display:
12 Press the "YES" key twice and the screen will
now display: (notice as the "YES" key is
pressed the status changes)
This needs to be repeated until all the zones are set back to all, then
continue to step 18.
13 Press the "NO" key three times and the screen
will now display:
14
position and the screen will display:

13. How To Put All The Zones Into Test Across A Network

How to put all the zones in to test across a Network (depending on which version of
software) on the 5000 FirePoint, insert the key into the Panels Control Key switch,
located at the right of the panel.
Step
No
1 With the key in the "ON" position, the screen
will display:
2
display:
3 Press the "∇" key three times and press the
"YES" key and the screen will now display:
4 Press the "∇" key until the screen displays:
5 Press the "YES" key and the screen will now
display:
6 Press 221100 then press the "YES" key and
the screen will display:
Turn the control
Action
Press the "0" key and the screen will now
key to the "OFF"
ENGINEERS OPERATING GUIDE, ISSUE 3.0 – 16/08/10
26
| Zone is : 02 |
> Status : Test <
|^^^^^^^^^^^^^^^^ |
Yes= Select Time
| Zone is : 02 |
> Status : ACTIVE<
|^^^^^^^^^^^^^^^^ |
Yes= Select Time
Panel in Access
Date Time
Status Normal
Date Time
Screen Display
Panel in Access
Date Time
|***Options **** |
> Passwords <
| Time and Date |
Yes = Select
|** Fire system ** |
> Dev. Disable/Test<
| Net. Disable/Test |
Yes= Select Time
| System Mode |
> Engineers Config <
| Printer Options |
Yes= Select Time
Enter Your PIN
For Access>
Then Press YES
Time
|** Eng. Config ** |
> Device Database <
| Sounder Options |
Yes= Select Time