How To Remove A Device - EMS FirePoint 5000 Operating Manual

EMS 5000 FIREPOINT
16
17
Note: After logging the device on to the system there will be two faults:-
st
1 fault is processor reset. (Silence and reset E.G. Page 5)
nd
2 fault is the Tamper. (Make sure the device tamper is clear then silence
and reset E.G. page 5)
18

9. How To Remove A Device

To remove a device from the 5000 FirePoint, insert the key into the Panels Control Key
switch, located at the right of the panel.
Step
No
1
2 Press the "0" key and the screen will now
3 Press the "∇" key until the screen displays:
4 Press the "YES" key and the screen will now
5 Press the "∇" key until the screen displays:
6
Press the "YES" key twice and the screen will
now display:
Press the "NO" key three times and the screen
will now display:
After the faults have been cleared, turn the
control key to the "OFF" position and the screen
will display:
Action
With the key in the "ON" position, the screen
will display:
display:
display:
Press the "YES" key and the screen will now
display:
ENGINEERS OPERATING GUIDE, ISSUE 3.0 – 16/08/10
18
| Slot is :IN USE |
>Logon is DISABLED<
| /\/\/\/\/\/\/\/\/\/\ |
01 FAULT TOT 02
Default Device 125
ZONE 01 DEVICE 125
Status Normal
Date Time
Screen Display
Panel in Access
Date Time
|***Options **** |
>Passwords <
| Time and Date |
Yes =Select Time
| Logging |
> Fire System Opts <
| Remote Access |
Yes = select Time
|** Fire system ** |
> Dev. Disable /Test <
| Net. Disable /Test |
Yes= Select Time
| System Mode |
> Engineers Config <
| Printer Options |
Yes= Select Time
Enter Your PIN
For Access>
Then Press YES
Time