How To Enter The System Event Log With Faults Displayed - EMS FirePoint 5000 Operating Manual

EMS 5000 FIREPOINT

3. How To Enter The System Event Log With Faults Displayed

To enter the system event log on the 5000 FirePoint with faults displayed there are two
ways.
The first way is to disable the devices that are in fault then enter the logging in the first
menu. The second way is to enter the engineer's menu main. To enter the engineer's
main menu insert the key into the Panels Control Key switch, located at the right of the
Panel and turn it to the "ON" position.
Step
No
1 With the key in the "ON" position, the screen will
display:
2 Press
now display:
3 Press the "∇" key until the screen displays:
4 Press the "YES" key and the screen will now
display:
5 Press 221100 then press the "YES" key and the
screen will display:
6 Press Number 8 on the keypad and the screen
will now display: (number is a quick move key
that takes you to the bottom of the menu)
7 Press the "∆" key until the screen displays:
8
9
10
Action
the "0" key
Press the "YES" key followed by the "0" key on
the keypad the screen will now display:
Press the "∇" key until the screen displays:
Press the "YES" key and the screen will now
display:
and the screen
ENGINEERS OPERATING GUIDE, ISSUE 3.0 – 16/08/10
8
Screen Display
01 FAULT TOT 03
Default Device
Zone 01 Device 001
|** Fire system **
>Dev. Disable/Test <
will
| Net. Disable/Test |
Yes= Select
|
System Mode
> Engineers Config <
| Printer Options
Yes= Select
Enter Your PIN
For Access>
Then Press YES
|** Eng. Config **
>Device Database
| Sounder Options |
Yes= Select
| Reset System
>Lan Options
|^^^^^^^^^^^^^^ |
Yes= Select
| Reset Security
>Reset System
|Lan Options
Yes= Select
|** Main Menu ** |
>Pins & Access
|System Support
Yes= Select
|Output Setup
>Logging
|Remote Rxers
Yes= Select
|**Event Logging * |
>View Log At Date <
| View Entire Log
Yes = Select Time
001
|
Time
|
|
Time
Time
|
<
Time
|
<
Time
|
<
|
Time
<
|
Time
|
<
|
Time
|