LEAB Automotive GmbH
U
phase: Charging with constant current
2
In this phase, the charging voltage is reduced in order to maintain the battery
charge for an unlimited period and counteract self-discharge. Additional connected
consumers are supplied via the charger in this phase without loading the battery.
Battery
Gel battery
Wet cell battery
AGM battery
7 Assembly
To assemble the device, proceed as follows:
ü Choose a cool, dry and well-ventilated assembly site.
ü Do not mount the device directly next to or above batteries.
ü Optimum cooling is achieved by mounting the unit vertically on a flat surface.
1. Fasten the device to the 4 mounting holes on the side (3) (Ø 5 mm).
ð The device is assembled.
8 Installation
The Champ charger is designed for permanent installation in vehicles.
8.1 Battery connection
To install the device in the vehicle, proceed as follows:
1. Disconnect the battery from the vehicle power circuit.
WARNING! Disconnect the negative lead first.
2. Secure the positive lead of the device as close as possible to the vehicle battery
with a suitable fuse.
3. Connect the positive lead of the device to the positive terminal of the battery.
4. Connect the negative lead of the device to the negative terminal of the battery.
NOTE! Connect the cable lug directly to the negative terminal of the battery.
5. Connect the vehicle battery to the vehicle power circuit.
ð The device is installed.
LEAB Automotive GmbH
Type
12 V
12 V
12 V
Thorshammer 6
8 Installation
Charge voltage
13.8 V
13.5 V
13.8 V
24866 Busdorf
43