8 Installation
Battery
AGM battery
7 Assembly
To assemble the device, proceed as follows:
ü Choose a cool, dry and well-ventilated assembly site.
ü Do not mount the device directly next to or above batteries.
ü Optimum cooling is achieved by mounting the unit vertically on a flat sur-
face.
1. Fasten the device to the 4 mounting holes on the side (3) (Ø 5 mm).
ð The device is assembled.
8 Installation
The Champ charger is designed for permanent installation in vehicles.
8.1 Battery connection
To install the device in the vehicle, proceed as follows:
1. Disconnect the battery from the vehicle power circuit.
WARNING! Disconnect the negative lead first.
2. Secure the positive lead of the device as close as possible to the vehicle
battery with a suitable fuse.
3. Connect the positive lead of the device to the positive terminal of the bat-
tery.
4. Connect the negative lead of the device to the negative terminal of the bat-
tery.
18
LEAB Automotive GmbH
Type
12 V
Notice
Device defect from shortening the negative lead.
Do not shorten the negative lead under any circumstances, as it
contains a temperature sensor.
LEAB Automotive GmbH
Charge voltage
13.8 V
Thorshammer 6
24866 Busdorf