LEAB Automotive GmbH
13 Appendix
13.3 MagCodePowerClip assembly instructions
To install the device, proceed as follows:
1. Cut off the old connector.
NOTE! Note the polarity of the wires.
2. Screw on the MagCodePowerClip.
3. Select the appropriate strain relief for the cable thickness.
4. If necessary, shorten the cable grommet by passing the cables through the grom-
met and the strain relief and attaching the wire end ferrules.
5. Screw the cables into the terminals.
NOTE! Note the polarity of the wires.
6. Screw the housing together.
ð The device is assembled.
LEAB Automotive GmbH
Thorshammer 6
24866 Busdorf
49