Magcodepowerport Installation Instructions - LEAB CHAMP 12 V User Manual

Hide thumbs Also See for CHAMP 12 V:

Table of Contents

Available languages

13 Appendix

13.2 MagCodePowerPort installation instructions

Fig. 3: MagCode

PowerSystems clip

and port

LEAB Automotive GmbH

NOTE! An existing car socket can easily be replaced by a

MagCode PowerPort, as both have the same diameter. If in-

stalling elsewhere, we recommend visiting a specialist work-

shop.

To install the MagCodePowerPort in place of an existing car

socket, proceed as follows:

DANGER! Short circuit hazard - Remove the fuse before

starting work.

1. Pull out the existing car socket.

NOTE! Note the polarity of the wires.

2. Cut the cable.

OR...

3. Drill a new installation opening (Ø 28 mm).

ð The installation opening is prepared.

4. Slide the MagCodePowerPort, with or without spacer ring,

into the installation opening.

5. Screw the MagCodePowerPort on the back with a nut

(M28).

6. Connect the cables with each other by soldering, crimping

or with connection terminals.

7. Put the fuse back in place.

ð The MagCodePowerPort is installed.

Thorshammer 6

LEAB Automotive GmbH

24866 Busdorf

Table of Contents

Table of Contents