Installation Instructions About this Manual Table of Contents About this Manual ................1 General Safety ..................2 About the Battery Charger ..............3 Package Contents ................. 3 Technical Specifications ............... 4 Charging Characteristics..............12 Setting Charging Characteristics ............12 Mounting ................... 13 Installation ..................
This manual supports safe handling of the device. Use the device solely in accordance with its intended use: The ABC charger from LEAB has been developed for permanent installation in vehicles for charging lead acid batteries. Thanks to their compact design,...
Installation Instructions About the Battery Charger Observe the following safety instructions: Danger from damaged, frozen or deformed batteries: Before charging, make sure that the battery is undamaged and the electrolyte is not frozen. Only charge batteries in well-ventilated rooms and away from ignition sources.
Installation Instructions Charging Characteristics Charging Characteristics The ABC charger contains 15 different charging characteristics which you can select before connecting to the battery. Battery charging is fully automatic and micro-processor controlled with a 3-stage IU characteristic curve for gentle and optimum charging of the batteries. The available charging characteristics can be found on the characteristics sheet.
Installation Instructions Mounting Mounting To mount the device, perform the following steps: Choose a cool, dry and well-ventilated mounting site. Do not mount the device directly next to or above batteries. To allow adequate cooling, ensure an unimpeded supply of cooling air.
Page 15
Installation Instructions Installation Connect the Device to the 230-V Mains To install the device to the 230-V mains, perform the following step: Connect the mains plug to a 230-V mains supply. The charger is only suitable for connection to fused, earthed 230-V networks.
Installation Instructions Normal Operation Connect CBL Control Relay (Optional) A potential-free changeover contact is integrated in the ABC chargers, which switches during charging operation. For easier connection, a corresponding adapter cable set with plug and three open cables is available. This option can be used, for example, to implement an electrical start interlock with 230-V connection or charge monitoring.
Installation Instructions LED Display on the Charger Charging the Battery The charger begins to charge the battery as soon as it is switched on. Switching off the Device To switch off the charger, perform the following step: For devices without an on/off switch, the device switches off as soon as the mains plug is disconnected from the 230-V mains.
Installation Instructions Maintenance 12 Maintenance Check the charger as follows before using it each time: Check the mains cable and mains plug for damage. Check charging cables and connections for damage. Check the charger for external damage. ...
Installation Instructions EU Declaration of Conformity 14 EU Declaration of Conformity The LEAB ABC with the models 1215, 1220, 1230, 1240, 1250, 2415, 2420, 2430, 3620 and 4815 complies with the requirements of the following directives: 2014/30/EU: 2014/35/EU: 2011/65/EU: RoHS...