Assembly; Installation; Battery Connection - LEAB Champ User Manual

8 Installation

U phase: Charging with constant current
2
In this phase, the charging voltage is reduced in order to maintain the battery
charge for an unlimited period and counteract self-discharge. Additional con-
nected consumers are supplied via the charger in this phase without loading
the battery.
Battery
Gel battery
Wet cell battery
AGM battery

7 Assembly

To assemble the device, proceed as follows:
ü Choose a cool, dry and well-ventilated assembly site.
ü Do not mount the device directly next to or above batteries.
ü Optimum cooling is achieved by mounting the unit vertically on a flat sur-
face.
1. Fasten the device to the 4 mounting holes on the side (3) (Ø 5 mm).
ð The device is assembled.
8 Installation
The Champ charger is designed for permanent installation in vehicles.

8.1 Battery connection

To install the device in the vehicle, proceed as follows:
1. Disconnect the battery from the vehicle power circuit.
WARNING! Disconnect the negative lead first.
12 LEAB Automotive GmbH
Type
24 V
24 V
24 V
Notice
Device defect from shortening the negative lead.
Do not shorten the negative lead under any circumstances, as it
contains a temperature sensor.
LEAB Automotive GmbH
Charge voltage
27.6 V
27.0 V
27.6 V
Thorshammer 6 24866 Busdorf