Assembly; Installation; Connecting The Battery; Connecting The Unit To The 230 V Mains - LEAB ABC SCHUTZKLASSE II User Manual

LEAB Automotive GmbH

8 Assembly

To assemble the unit, proceed as follows:
ü Choose a cool, dry and well-ventilated assembly site.
ü Do not mount the unit directly next to or above batteries.
ü Guarantee adequate cooling for an unimpeded supply of cooling air.
1. Fasten the assembly bracket to the unit using the 4 lateral holes (5 mm Ø).
ð The unit is assembled.

9 Installation

9.1 Connecting the battery

To connect the battery, proceed as follows:
1. Disconnect the battery from the vehicle power circuit.
WARNING! Disconnect the negative cable first.
2. Secure the positive cable of the device as close as possible to the vehicle
battery with a suitable fuse.
3. Connect the positive cable of the unit to the positive terminal of the bat-
tery.
4. Connect the negative cable of the unit to the negative terminal of the bat-
tery.
5. Connect the vehicle battery to the vehicle power circuit again.
ð The battery is connected.

9.2 Connecting the unit to the 230 V mains

To connect the unit to the 230 V mains, proceed as follows:
1. Connect the mains plug to a 230 V mains.
ð The charger is connected to the 230 V mains.
LEAB Automotive GmbH Thorshammer 6
9 Installation
24866 Busdorf 13