Assembly - LEAB CHAMP PRO 24 V User Manual

LEAB Automotive GmbH
Charging characteristic: POWER SUPPLY
Champ Pro chargers In the "Power Supply" setting can also be used without
the battery connected to supply DC consumers. This setting can be used, for
example, when replacing the battery in the vehicle to avoid on board com-
puter and radio data loss due to the loss of power and having to be repro-
grammed.
Note that the power required must be no higher than the output power of the
charger. In the "Power Supply" setting, the charger gives off a constant voltage
of 13.7 V or 27.4 V. The green LED of the charge status indicator is continuously
lit. The "Power Supply" setting also allows deeply discharged batteries to be
reactivated so that they be identified and recharged by one of the automatic
loaders. After reaching the minimum voltage, switch to the appropriate char-
ging characteristic.

7 Assembly

To assemble the device, perform the following steps:
ü Choose a cool, dry and well-ventilated assembly site.
ü Do not mount the device directly next to or above batteries.
ü Optimum cooling is achieved by mounting the unit vertically on a flat sur-
face.
1. Fasten the device to the 4 holes on the side (Ø 5 mm)
ð The device is assembled.
Setting the charging characteristic for the first time
To select a charging characteristic, perform the following steps:
1. Connect the mains plug to a 230 V mains supply.
2. Within 3 to 6 seconds, press the Mode button repeatedly until the LED next
to the desired charging characteristic is lit on the display (4).
3. Disconnect the charger from the 230 V mains.
ð The charging characteristic is set.
LEAB Automotive GmbH Thorshammer 6
7 Assembly
24866 Busdorf 15