Table of Contents
Advertisement
7 Setting the Charging Parameters
5 Package Contents
Item
Battery charger
User manual
6 Assembly
To assemble the device, proceed as follows:
ü Choose a cool, dry and well-ventilated assembly site.
ü Do not mount the device directly next to or above batteries.
ü Guarantee adequate cooling for an unimpeded supply of cooling air.
1. Fasten the device to the side holes (5 mm Ø) on a flat surface.
ð The device is assembled.
7 Setting the Charging Parameters
The RBC charger contains 30 different charging parameters (charging charac-
teristic, battery capacity and charging mode) which you can select before con-
necting to the battery. A graphical illustration of the charging characteristics
can be found in Appendix [
To set the charging parameters, proceed as follows:
ü Before setting, select the desired settings using the table below.
ü The charger is disconnected from the 230 V mains.
ü The charger is not connected to the battery.
1. Connect the mains plug to a 230 V mains supply.
2. As soon as the 'Ready for operation' LED lights up blue (after approx. 5 s),
press the STOP button for 10 s until all LEDs are flashing briefly.
ð You are in configuration mode.
NOTE! When first used, charging parameters 1 (charging characteristic
LK10-06) and 9 (battery capacity 50 Ah) are preset by default.
3. To select a parameter from the list, keep pressing the STOP button until you
reach the desired position.
12
LEAB Automotive GmbH
22] .
}
Thorshammer 6
LEAB Automotive GmbH
No.
1x
1x
24866 Busdorf
Advertisement
Table of Contents
