Fisher & Paykel OR36SDG User Manual page 45

Cooktop burners
PROBLEM
There is no clicking when
I try to light a burner.
There is a power failure –
can I still use the cooktop
burners?
The flames have suddenly
gone out.
There is a slight
'extinction pop' or
flash after I've turned
a cooktop burner off.
The burner flames are
uneven, very large, yellow
or yellow-tipped or sooty.
TROUBLESHOOTING
POSSIBLE CAUSES
The ignitor is dirty or there is a
power outage.
Power outage in your area.
A draft or a spill has extinguished
the flame.
Technical fault: the gas is the wrong
type or hasn't been
adjusted properly.
WHAT TO DO
Clean the ignitor(s). See 'Care and
cleaning' for instructions.
The cooktop burners can still be
used. To light them:
1 Holding a lighted match to
the flame spreader, push in
on the control dial and turn
counterclockwise to HI.
2 When the flame is burning all
the way around the burner,
you may adjust the heat.
IMPORTANT!
If the flame is blown out
during a power failure, turn
the dial immediately to O
(OFF), as the burner will not
automatically relight and
gas may escape.
No action required. The burner
will detect this and automatically
relight. However, if there has
been a large spill, we recommend
turning the burners off and
cleaning the burners and sump
area. See 'Care and Cleaning'
for instructions.
This is normal for LP gas and
requires no action.
Do not use your cooktop burners.
Contact your Authorized Service
Center or Customer Care.
45