Fisher & Paykel OR36SDG User Manual page 28

If a burner does not light
Turn the control dial to O (OFF) and wait at least one minute before trying again, to all the
gas to disperse.
If the burner still does not light, check that:
the range is plugged in and the power supply is switched on
z
there is no power failure in your home or neighbourhood
z
the gas is turned on
z
the gas bottle is not empty (if you use bottled gas)
z
the flame spreaders are clean and the holes are not clogged
z
the ignitors are sparking. If they are not sparking, they may be dirty or wet. Clean them
z
with a toothbrush and methylated spirits, as shown below.
See 'Care and cleaning' for instructions on removing and replacing the burner parts.
Cleaning the ignitor
If the flame is irregular Check that the burner parts
(flame spreader and burner cap) are:
clean and dry
z
positioned correctly, as shown below.
z
For further advice, see sections 'Care and cleaning' and 'Troubleshooting'.
z
Burner cap
Ignitor Flame spreader
Burner parts
28
COOKTOP USE
Ignitor
Correct assembly of
burner parts
Incorrect assembly of
burner parts, resulting in
irregular flames