Burner Controls
The dials control the flow of gas through the valve.
Using the single burners
1 Identify the dial of the burner
you want to use.
2 Starting from the O (OFF) position, push
the dial in and turn it counterclockwise
to HI to light the burner.
4 When the burner has lit, adjust the
flame anywhere between HI and LO.
Do not adjust the dial between
z
HI and O (OFF).
GRAPHICS LOCATION
COOKTOP USE
GRAPHICS LOCATION
Using the dual burner
3 Starting from the O (OFF) position, push
the dial in and turn it counterclockwise
to either HI
and outer rings or HI
inner ring only.
5 When you have finished cooking, turn
the dial clockwise back to O (OFF).
If you are using LP gas, there may be
z
a slight 'extinction pop' or flash at the
flame spreader a few seconds after
the burner has been turned off. This is
normal for LP gas.
to light both the inner
to light the
27