Fisher & Paykel OR36SDG User Manual page 35

Manual cleaning chart
WHAT?
COOKTOP PARTS
Burner caps and
flame spreaders
Ignitors
Burner grates
Wok ring
CARE AND CLEANING
HOW?
1 Check that the burner is turned OFF and
allow it to cool.
2 Lift off the burner cap and brass
flame spreader.
3 Wash them in hot soapy water,
rinse, and dry.
• Use a stiff nylon brush or straight-ended
paper clip to clear the notches of the
flame spreader.
4 Replace the flame spreader and
burner cap correctly. See 'Replacing
the burner parts'.
1 Check that the burner is turned OFF.
2 Clean the ignitor with a small brush (e.g.
old toothbrush) or cotton swab that has
been dipped into rubbing alcohol.
1 Wait until the grates have
cooled completely.
2 Carefully lift the grates off the cooktop
and place them on a protected surface.
3 To remove stubborn stains, soak the
grates in a mixture of clothes washing
detergent and water.
4 Wash in a mixture of hot water
and dishwashing liquid, then rinse
and allow to dry.
•
The grates are also dishwasher-safe.
1 To remove stubborn stains, soak the
grates in a mixture of clothes washing
detergent and water.
2 Wash in a mixture of hot water
and dishwashing liquid, then rinse
and allow to dry.
• The wok ring is also dishwasher-safe.
IMPORTANT!
• Keep the notches of the flame
spreaders clear. Soiling may
clog these and cause ignition
problems.
• Before replacing the burner
parts, check that they are dry.
Wet burner parts may result in
an irregular flame.
•
Before lighting a burner you
have reassembled, check that
all of its parts are positioned
correctly. Incorrect assembly
can cause dangerous irregular
flames and ignition problems.
• Do not put burner parts in the
dishwasher as they will become
discolored.
• The ignitors must be kept clean
and dry to work correctly. Dirty
or wet ignitors could cause
constant clicking and sparking,
even if a flame is present.
•
Take care, the grates are heavy.
• Make sure you place a dish
towel or other soft cover on the
surface before putting a grate
on it.
35