Chapter 3 Installation and Wiring
3.2 Remote control keypads and wiring connection
STEP 1.Hand on the notch of the two sides( right and left) of the keypad and
pull it up by inward,remove the keypad.(as shown in the figure 3-4).
Fig. 3-4
STPE 2.Install the optional interface board at the position of keypad.(as
shown in the figure 3-5).
Fig. 3-5
-16-
Chapter 3 Installation and Wiring
STEP 3.Insert the optional cable with the grounding side into the slot of
interface board. (as shown in the figure 3-6).
Fig. 3-6
STEP 4.Put the dismantled keypad into the installation frame . Fix and
fasten it . Put the other side cable insert into the keypad .(as shown in the
figure 3-7).
Fig. 3-7
-17-