Table of Contents
Advertisement
Objet350 User Guide
3. When instructed to do so, place the transparency on the build tray—next to
4. Make sure that the transparency sheet is lying flat, and tape it to the tray.
5. Close the printer cover.
6. In the wizard screen, select the check box to confirm that the transparency
7. Open the printer and remove the transparency.
DOC-17001 Rev. L
the left and rear edges of the tray, as shown in the following figure.
Figure 6-50 Positioning the transparency on the build tray
sheet is secured to the build tray, and click Next.
When you click Next, the printer prints the head alignment test on the
transparency. When printing is finished, the following screen appears.
Figure 6-51 Head Alignment wizard—steps 7–9
The transparency sheet is printed with sets of vertical lines in seven columns,
each showing the results from a different print head.
Figure 6-52 Sample head-alignment test
Note: There is no column for head H7 because its alignment is used as a
reference for aligning all other heads.
6 Operating and Maintaining the Printer
6-44
Advertisement
Table of Contents
