Objet350 User Guide
UV Measurement
The UV lamps power up and stabilize. (This takes several minutes.) Then, the
print block passes over the sensor and the wizard compares the measured
radiation to the recommended level for each UV lamp. During this process, which
takes 20–40 minutes, you need to monitor the progress as displayed in the
wizard screen.
Figure 6-102 UV measurement progress
When using a stand-alone radiation meter (not the Stratasys UV sensor box
connected to the printer): Reset the meter and enter the reading (measurement)
when you are prompted to do so.
Figure 6-103 UV Measurement dialog box
DOC-17001 Rev. L
6 Operating and Maintaining the Printer
6-72