Objet350 User Guide
material in the supply cartridges, printing proceeds automatically until the job is
finished.
During printing, the server computer must remain on and it must
communicate with the Objet350 printer. Do not log-off Windows until printing
is finished.
The Objet350 printer uses one, two or three Model-material cartridges and one
Support-material cartridge to produce models. If additional cartridges are
installed and they are not immediately needed for printing, the printer interface
indicates this (see "Printer Interface Color Key" below).
Printer Interface Color Key
The background colors in the printer indicator fields tell you at a glance whether
or not the value or item is suitable or ready for printing.
• Green—suitable/ready for printing
• Blue—not ready
• Red—not suitable for printing (or indicates a warning)
The color of the material cartridges displayed in the printer interface indicates
which cartridges are active for the current (or next) print job.
For example, in Figure 6-3 on page 6-4:
• Blue—active cartridge
• Gray—reserve cartridge
DOC-17001 Rev. L
For example, in Figure 6-4 on the previous page:
❒ Heads (°C)—The heads have reached the temperature required for
printing models.
❒ Ambient—The ambient temperature of the printing chamber is within the
acceptable range.
❒ Heads Liquid—The level of Model and Support material in the print-block
reservoir is OK.
❒ Heads Vacuum—The vacuum level in the system is within the acceptable
range.
❒ Pre-Heaters—The Model and Support resins have been heated to the
required temperature before being supplied to the print block.
For example, in Figure 6-4 on the previous page:
❒ UV lamps—The UV lamps are not on.
For example, in Figure 6-4 on the previous page:
❒ Waste—The weight of the waste container is 9000 grams, more than
allowed when beginning a print job. (See "Replacing the Waste
Container" on page 6-91.)
6 Operating and Maintaining the Printer
6-8