Objet350 User Guide
23. C lose the printer cover.
24. A fter replacing print heads, you should run the wizard again, to optimize the
Installation Problems
If the printer detects that there is a problem after you install print heads, a
relevant warning screen appears.
➢ If the printer software does not detect the replaced head:
DOC-17001 Rev. L
The wizard continues by heating the heads, then filling and purging them. If
there are no installation problems, the optimization procedure begins, to
calibrate the print heads to the best working configuration—see "Optimizing
(Calibrating) Print Heads" on page 6-47.
If installation problems are detected, the wizard alerts you and instructs you
how to continue (see "Installation Problems" below).
new heads, and to make sure that they are optimized for printing with the
other heads. In the final wizard screen, select Optimize all print heads and
click Next.
Figure 6-88 Final wizard Screen
a. Open the print head compartment (see Figure 6-78 on page 6-60).
b. Re-insert the print-head driver card into its socket (see Figure 6-82 on
page 6-61).
6 Operating and Maintaining the Printer
6-64