Objet350 User Guide
Recess-Up Rule
This rule considers models containing surface recesses.
➢ Recesses in the surface (like hollows, drill holes, etc.) should, when possible,
Fine-Surface Rule
This rule considers models that have one side on which there are fine details (like
the keypad side of a telephone).
➢ The side of the model containing fine details should, when possible, be
Avoid Support-Material Rule
This rule considers models that have large holes or hollows, open on at least one
side (like a pipe or a container).
➢ It may be advantageous to print a model standing up, so Support material
DOC-17001 Rev. L
be positioned face-up.
positioned face-up. This results in a smooth finish.
does not fill the hollow, even though printing the model lying down would be
much faster.
5 Using Objet Studio
5-32