Table of Contents
Advertisement
Objet350 User Guide
8. Remove any pieces of waste material collected in the purge unit.
9. Inspect the wiper.
10. I n the wizard screen (see Figure 6-32), confirm that the wiper blade is clean,
11. R emove all tools and cleaning materials from the printer, and close the cover.
DOC-17001 Rev. L
If necessary, remove the waste collector to clean it. Wipe the rubber seal.
Figure 6-33 Purge unit waste collector
Note: When returning the waste collector to the purge unit, make sure to
insert it as shown.
If the wiper is scratched, torn or worn, or if you cannot clean it completely,
replace it:
a. Grasp it and pull it up and out of its bracket.
b. Insert the new wiper blade, making sure that it is straight and secured well
on both sides.
and click Next.
6 Operating and Maintaining the Printer
6-34
Advertisement
Table of Contents
