Relamping Instructions; Replacing Low-Pressure Lamps - Heartland Ovation 5400 Owner's Manual

INSTRUCTIONS
CAUTION
Replacement lamps must comply with CFR 21 1040.20 When ordering lamps, include
model number and serial number.
5400
Replace only with Rave 160 APR 1841, Rave 12071 R 1989 & Hereaus E-400 HPT lamps for
facial.
6400
Replace only with Rave PREFFERED 1885, System Varius 80010522 & Hereaus OHC 560
500W lamps for facial.
REPLACING LOW-PRESSURE TANNING LAMPS
5400 and 6400
BENCH
1. Disconnect power from unit.
2. Unlock the front bench acrylic locks (use 5/32 allen wrench)
3. Hinge the acrylic open by lifting up on the front edge.
Note: The acrylic should stay in the open position.
4. Remove the inner acrylic and set aside. (6400 only)
5. Turn the bi-pin lamp 90 degrees and remove from lamp holder.
6. Align the bi-pin lamp, slide the top and bottom into the lamp holder turn 90
degrees.
7. Reinstall inner acrylic (6400 only)
8. Clean and close the acrylic.
9. Use 5/32 allen wrench to lock bench acrylic.
10. Reconnect power to unit.
CANOPY
1. Disconnect power from unit.
2. Remove the screws from the canopy handle/acrylic retainer.
3. Holding the acrylic, hinge the handle/acrylic retainer open and remove
acrylic.
4. Turn the bi-pin lamp 90 degrees and remove from lamp holder.
5. Align the bi-pin lamp, slide the top and bottom into the lamp holder turn 90
degrees.
6. Clean acrylic and reinstall.
7. Hinge the handle/acrylic retainer closed and reinstall the screws.
8. Reconnect power to unit.
IMPORTANT NOTE – 2 people are required when removing and installing
canopy acrylics on these units, 1 person at each end of bed.
www.heartlandtan.com
RELAMPING
15 12/06