Heartland Ovation 5400 Owner's Manual page 43

INSTALLATION INSTRUCTIONS
10) Position bench end caps back into place. Be sure that the speaker wires are at
the head end of the bed. See picture 10 and picture 8 for proper handling.
11) Secure each end cap to the base by tightening the four screws on each
end cap. Plug in each BF cord to the body fan attached to each end cap.
See picture 7.
12) Set the base door (attach door safety cable) and left-hand back light panel in
place, in the open position. (Protect back light lamp)
13) Push the RCA jacks, 4-pin connector, speaker wire and back light panel wires
back through the hole and reinstall the grommet. Secure back light panel to
base. See picture 3.
14) Plug in the display cord, RCA jacks, 4-pin connector, speaker wire and the
ground wire coming from the component tray. Reattach antenna to audio
amp. Refer to picture 2
15) Plug in the ground wires for each ballast tray and the two that go the top of the
base. Refer to picture 6. Also, be sure that you plug in the temperature switch.
See picture 5.
16) Close the base door and tighten down bolts.
17) Unwrap and carefully install front façade. See picture 12.
YELLOW SECTION IN ANY WAY. *** SCRATCHES ARE NOT COVERED BY WARRANTY *** . This
is a delicate and easily damaged piece.
18) Set the bench acrylic in the down position and lock into place using the 5/32
Allen wrench provided. NOT DOING THIS WILL CREATE AN AIRFLOW PROBLEM,
VOID YOUR WARRANTY AND DIMINISH THE LIFE OF THIS UNIT.
19) Carefully install canopy skin.
SCRATCHES ARE NOT COVERED BY WARRANTY *** .
rail, one person will need to go around to the front to hold up that side. The
other person will need to make sure that the cords are properly in the cord
notch and that the exhaust fans have moved into position. Place front edge into
its slot on the front rail. See picture 11
20) Install canopy end caps, check for proper alignment. Tighten all bolts (10-24 x 1
¼) and install filters.
21) Reconnect the body fan hoses to the underside of the bench. THE HOSE
COMING FROM THE FOOT END MUST BE CONNECTED TO THE BACKSIDE VENT
OPENING. Tighten as shown in pictures 13 and 14
www.heartlandtan.com
6400
DO NOT SCRATCH THE YELLOW SECTION IN ANY WAY. ***
40
DO NOT SCRATCH THE
Set the backside in to slot on the
12/06