Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
The 5400 tanning bed is a completely assembled unit when shipped. Disassembly is required to get
it to its final location in the tanning room. Follow the instructions below on disassembly and
reassembly of this unit. To complete the installation three people are required. If at any time during
installation, you have a question call our service department @ 800/554-8268 before proceeding
any further.
TOOLS NEEDED:
7/16" Socket or Wrench, 9/16" Socket or Wrench
•
5/16" Allen Wrench
•
#2 Phillips Screwdriver
•
Side cutters
•
STEP 1.
Uncrate your 5400 unit and discard packaging.
Note: If the size of your tanning room door is, greater than 36" skip to step #5.
STEP 2.
Remove the filter and (3) three screws underneath the filter that attach canopy end caps
to the frame. Hold onto the end cap while removing the last screw.
STEP 3.
Carefully remove canopy skin. Note the red and black wires under the light display that
need to be unplugged. Three people needed for this step. This is a delicate and easily
damaged piece. Set in a secure location until you are ready to reinstall. Do not stand on
end.
STEP 4.
Using the 5/16 Allen wrench provided unlock the bench acrylic and lift acrylic to the up
position. See picture 4.
STEP 5.
Unplug the ground wires on the front of each ballast tray and the two connected to the
bench. See picture 2
STEP 6.
On the base door, unplug the red and gray RCA jacks noting that the red is on the
bottom and the gray is on the top. Unplug the 4-pin connector (top right) and the
speaker wires (left to right) white, black, green and red. Unthread the antenna from the
audio amp.
STEP 7.
Push the RCA's jacks, 4-pin connector and the speaker wire through the hole with the
grommet that is located on the left-hand side of the base. See picture 7 for reference.
STEP 8.
Unplug the display cable located on the bottom left board and unplug T-1 on the
component tray. Then unplug the ground wire coming from the base door to the
component tray. Remove base door and set aside. Note the wing nut and safety cable
attached to the right side.
STEP 9.
Unplug wire harnesses from ballast trays B1, B2,B3,B4,C1,C2,C3,C4,C5,C6 and P1
through P12 including plugs "BF" and "1" from the ballast trays inside the base; note the
numbers. See Picture 1. Cut the cable ties on the front of each ballast trays and
carefully remove ballast trays, noting positions.
STEP 10.
Loosen the (2) two cord plates at the back of the base, Pull the canopy harnesses
through the holes. Take care in removing so that no damage occurs to the wires or
connectors.
www.heartlandtan.com
5400
29
12/06
Hide quick links:
Advertisement
Table of Contents
