Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
With the 6400 base ready to move. Refer to picture below showing the minimum
clearance from the wall on the floor where the corners of the base will go.
1)
Place the base in the area you have marked.
2)
Install the ballast trays; refer to your notes and Picture 6 for proper placement.
3)
Connect cords P1 through P12.
4)
Set the bench in place. Be sure to position centering tabs to the inside for proper
alignment. The bench cords must drop straight down do not let them get
pinched. Refer to picture 9
5)
Install shoulder tanner glass reflectors. Carefully place over lamp and turn 90º
clockwise.
6)
Connect cords B1, B2, B3 AND B4 along with cord BF.
7)
Install canopy and tighten the two lift arm screws that secure canopy to the lift
arms. See picture 15
8)
Place canopy cords back inside the base and install cord plates. Be careful not
to damage wires or the plugs.
9)
Connect cords C1, C2, C3, C4, C5, C6 and the cords labeled as 1, F1
www.heartlandtan.com
6400
39
12/06
Hide quick links:
Advertisement
Table of Contents
