Heartland Ovation 5400 Owner's Manual page 35

INSTALLATION INSTRUCTIONS
With the 5400 base ready to move. Refer to picture below showing the minimum
clearance needed from the wall. Using Masking tape to mark the position on the floor
where the corners of the base will go.
1) Place the base in the area you have marked.
2) Install the ballast trays; refer to your notes and picture 2 for proper placement.
3) Connect cords P1 through P12.
4) Set the bench in place and install the screws removed earlier. Refer to picture 4 for the
backside positions. Be sure to position centering tabs to the inside for proper alignment. The
bench cords must drop straight down, do not let them get pinched. Refer to picture 6.
5) Connect cords B1, B2, B3 AND B4 along with cord BF.
6) Install canopy and tighten lift arm screws to secure canopy to the lift arms. See picture 13
7) Place canopy cords back inside the base and install cord plates. Take care not to
damage wiring or plugs. Refer to picture 5.
8) Connect cords C1, C2, C3, C4, C5, C6 and the cords labeled as 1 and F1
9) Position bench end caps back into place. Be sure that the speaker wires are at the head end
of the bed. See picture 3 for proper handling, picture 6 for wires only.
www.heartlandtan.com
5400
32 12/06