Heartland Ovation 5400 Owner's Manual page 39

INSTALLATION INSTRUCTIONS
The 6400 tanning bed is a completely assembled unit when shipped. Disassembly is required to
get it to its final location in the tanning room. Follow the instructions below on disassembly and
reassembly of this unit along with your taking of notes. To complete the installation three
people are required. IF YOU HAVE A QUESTION AT ANY TIME DURING THIS INSTALLATION, STOP
AND CALL OUR SERVICE DEPARTMENT @ 800/554-8268 BEFORE PROCEEDING ANY FURTHER.
TOOLS NEEDED:
7/16" Socket or Wrench, 9/16" Socket or Wrench
•
5/16" Allen Wrench (provided)
•
#2 Phillips Screwdriver
•
5/16 nutdriver
•
STEP 1. Uncrate your 6400 unit and discard packaging.
Note: If the size of your tanning room door is, greater than 36" skip to step #5.
STEP 2. Remove the filter and (3) three screws underneath the filter that attach canopy end
caps to the frame. Hold onto the end cap while removing the last screw.
STEP 3. Carefully remove canopy skin by lifting up on both sides. DO NOT SCRATCH THE
YELLOW SECTION IN ANY WAY. *** SCRATCHES ARE NOT COVERED BY WARRANTY *** .
You will need a third person here. One person will need to hold up the front side as
another makes sure that the canopy skin clears the exhaust fans and canopy cable
harness. Lift skin up and away from canopy frame. This is a delicate and easily
damaged piece. Set in a secure location until you are ready to reinstall. Do not
stand on end. See picture 11
STEP 4. Using the 5/16 Allen wrench provided unlock the bench acrylic and lift acrylic to the
up position. See picture 1.
STEP 5. Open the base door and unplug the RCA jacks. Unplug the 4-pin connector, the red
display cable and the speaker wires along with the Lt. Blue and tan wire connector.
Unthread the antenna from the audio amp. See picture 2.
STEP 6. Remove the three screws that attach the left-hand back light panel to the base.
Do not set aside until completing step 7. See picture 3
STEP 7. Push the RCA's jacks, 4-pin connector and the speaker wire through the hole with
the grommet that is located on the left-hand side of the base. Then take left-hand
back light panel to a safe area until needed. See picture 10
STEP 8. Unplug the display cable located on the bottom left board and plugs labeled T-1,
T-2 and S-1 inside the base (front and back left). Then unplug the ground wire
coming from the base door to the component tray. Remove base door and set
aside. Note the wing nut on the right that secures the safety cable.
STEP 9. Unplug wire harnesses from the ballast trays B1,B2,B3,B4,C1,C2,C3,C4,C5,C6,F1 and
P1 through P12 including plugs "BF" and "1" from the ballast trays inside the base;
note the numbers.
www.heartlandtan.com
6400
36 12/06