Relamping Instructions - Heartland Ovation 2800 Owner's Manual

RELAMPING
INSTRUCTIONS
2800
Replace only with Rave 5071 100W lamps, Rave 5059 80W lamps and Hereaus
400W lamps (Facial unit, where applicable)
3400, 3400/3
Replace only with Rave 5071 100W lamps and Hereaus 400W lamps (Facial unit,
where applicable)
3400R, 3400R/3
Replace only with Rave 10071 R 100W lamps and Hereaus 400W lamps (Facial
unit, where applicable)
3400S, 3400S/3
Replace only with Rave Select 100W lamps and Hereaus 400W lamps (Facial
unit, where applicable)
REPLACING LOW-PRESSURE TANNING LAMPS
2800 AND 3400
1. Disconnect power from unit.
2. *Remove the quarter-turn screws from acrylic strips and remove acrylic
from unit.
3. Turn the bi-pin lamp 90 degrees and remove from lamp holder.
4. Align the bi-pin lamp and slide the top and bottom into the lamp holder.
Turn 90 degrees.
5. Clean acrylic and reinstall acrylic strips.
6. *Reinstall acrylic and install screws.
7. Reconnect power to unit.
* Please note - when removing and installing canopy acrylics on these units -
requirement is 2 people, 1 person at each end of bed.
www.heartlandtan.com 23 10/27