Heartland Ovation 5400 Owner's Manual page 40

INSTALLATION INSTRUCTIONS
STEP 10. Unplug the ground wires (picture 6) on the front of each ballast tray and the two
connected to the bench. Also, unplug the temperature switch located on the base
shown in picture 5.
STEP 11. Cut the cable ties on the front of the ballast trays and remove ballast trays, noting
positions.
STEP 12. Loosen the two cord plates at the back of the base and pull the canopy harnesses
through the holes. Take care in removing so that no damage occurs to the wires and
connectors. See picture 4
STEP 13. Using a 7/16 wrench or socket loosen the (2) two bolts located on the canopy arm.
Lift the canopy straight up as a team at the same time. Carefully set the canopy to
the side. Note the canopy is in the up position. A third person will be helpful here.
STEP 14. Underneath each end of the bench, unplug the body fan cords. Secure wires to
prevent damage. Disconnect the body fan hoses from the bench. Do not
disconnect at the body fan. See pictures 7, 13 and 14.
STEP 15. Remove the bench end caps by first loosening the (4) four retaining screws on
each side and lifting up and out on the end caps. See picture 8 for proper
handling of end caps when removing.
STEP 16. Remove the (4) four screws that fasten the bench to the base (2) two are in the
front rail and (2) two are in the back rail. Also on the backside there are (4) four
screws that hold the base covers to the bench. See picture 4
STEP 17. Lift the bench straight up and out, set aside. Three people are required to complete
this step. A third person to hold the cords so no damage occurs. See picture 9
Picture 1
www.heartlandtan.com
6400
Picture 2
37
Picture 3
12/06