Heartland Ovation 5400 Owner's Manual page 22

OVERVIEW
Congratulations on your purchase of Applied Digital, Inc.'s T-Max™ Series of tanning bed timers. The
T-Max™ Series is designed for complete automation and control of your tanning equipment. A
5400/6400 Timer is an OEM board that can be installed in a tanning bed or tanning booth. Each
5400/6400 Timer can individually control a tanning bed, can be connected back-to-back with a T-
Max™ 1A or T-MAX™ 3A for remote front desk control or be connected with many Heartland Timers
and a T-Max™ Manager or Manager/Plus/Pro to control many beds from a remote location.
Operation is accomplished via front panel controls. The licensed electrician installing your T-Max™
timing system should use this manual. Check for compliance with local building codes.
CONFIGURATION
Setting Bed Address
Note: If you are using a T-Max™ Manager or T-Max™ Manager/Plus/Pro and multiple 5400/6400 Timers,
remove power from the T-Max™ Manager or T-Max™ Manager/Plus/Pro and keep the power removed
until all parameter changes are complete.
1. Press and hold the FAN UP button on the 5400/6400 Timer. As soon as you see, "Total Bed Hours"
release the button. This should take about 5-6 seconds.
2. Press the FAN UP button until the "Bed Address" screen is displayed.
3. Follow the directions displayed by pressing the TIME UP button to advance in number. Press the TIME
DOWN button to decrease in number.
4. To exit the program mode and make the 5400/6400 Timer available for the next session, press the
FAN UP button until the display shows the OVATION™ screen.
Preset Functions
The 5400/6400 Timer is a user friendly sophisticated diagnostic tool that can be tailored to each user's
personal needs. From the display, the user can change the following preset functions.
1. START/STOP -
By pressing this button the user can start or pause a session.
NOTE:
Once a session has been started, all timer buttons are locked until the startup
sequence has finished. In addition, once a session has been paused the high-pressure lamps
will not restart until they have cooled. This may take up to 3 minutes depending on
temperature.
2. TIME UP-TIME DOWN -
decrease the session to the desired time. Once a session has started the TIME UP key has no
function.
3. FACIAL UP-FACIAL DOWN -
button lowers the output of the facial lamps from 500 watt to 300 watt to off. The FACIAL UP button
raise the facials to 500 watts from the lower setting.
NOTE: Once the facials have been switched OFF, they will not cycle on until the lamps are ready.
The display will show a 1 minute delay before the timer will attempt to restart the facials.
SHOULDER -
4. This button cycles the shoulder tanning lamps ON/OFF.
Note:
Shoulder Tanners are not available on the 5400 model.
5. FAN UP-FAN DOWN -
(high) to 3 (med.) to 2 (low) to 1 (ultra low) to 0 (off). The FAN UP button raises the body fan speed
up to 5 (ultra high).
The Salon Owner can monitor lamp hours, session's totals and Tailor specific functions on the
5400/6400 Timer from their T-Max™ Manager. Level 3 security is required to "GET or SEND"
parameters listed on page 47.
www.heartlandtan.com
When the unit is in manual mode these buttons are used to increase or
The 5400 has two facial settings, on or off. The 6400 FACIAL DOWN
The FAN DOWN button lowers the body fan speed from 5 (ultra high) to 4
19 12/06