Heartland Ovation 5400 Owner's Manual page 36

INSTALLATION INSTRUCTIONS
10) Secure the end caps to the base by tightening the 4 screws that are on each end of
the bench. Plug in each BF cord on the body fan attached to each end cap.
11) Reinstall rubber grommet and the RCA jacks, 4-pin connector and the speaker wire
back in it location on the base. Take in not damaging the wire or connections. See
picture 7.
12) Next get the base door and set it in place, in the open position.
13) Plug in the display cord, RCA jacks, 4-pin connector, speaker wire and the ground wire
coming from the component tray. Reattach antenna to audio amp. See picture 12
14) Plug in the ground wires for each ballast tray and the two that go to the top of the
base. Refer to picture 2.
15) Close the base door and tighten down top bolts.
16) Unlock bench Canopy (See picture 4) and raise it to the up position. Unwrap and
carefully install front façade. Lower bench acrylic and lock in place (picture 4) NOT
DOING THIS WILL CREATE AN AIRFLOW PROBLEM, VOID YOUR WARRANTY AND DIMINISH
THE LIFE OF THIS UNIT.
17) Carefully install canopy skin. Set the backside in to slot on the rail (as shown in picture
8), one person will need to go around to the front and plug in the red and black wires
while holding up that side. The other person will need to make sure that the cords are
properly in the cord notch and that the exhaust fans have moved into position. Place
front edge into its slot on the front rail.
18) Install canopy end caps, check for proper alignment. Tighten all bolts (10-24 x 1 ¼)
and install filters.
19) Carefully place Ovation and 5400 plates in position.
Picture 7
www.heartlandtan.com
5400
33
Picture 8
12/06