Replacing High-Pressure Shoulder Tanner Lamps - Heartland Ovation 5400 Owner's Manual

REPLACING HIGH-PRESSURE SHOULDER
TANNER LAMPS
6400
1. Disconnect power from unit.
2. Hinge acrylic bench open.
3. Remove the glass reflector by pushing in and turning 90 degrees counter
clockwise and set aside.
4. Remove the aluminum reflector by removing two (2) #10-24 screws and lifting
straight up on the reflector.
5. Disconnect the shoulder tanners from the power source.
6. Remove the base from the mounting bracket by pressing down on the
retainer clips tabs and pulling outward on the base.
Note: The base and lamp are one unit.
7. Discard the base and lamp assembly and install the new base to the
mounting bracket.
Note
DO NOT GRASP BY THE LAMP; ALWAYS USE ALCOHOL TO WIPE OFF LAMP AFTER
INSTALLATION.
8. Reverse steps 1-6 to complete lamp change.
CAUTION
ALWAYS WEAR UV PROTECTIVE EYEWEAR WHEN REPLACING LAMPS AND
CHECKING OPERATION.
www.heartlandtan.com 17 12/06