Related Manuals for DFI EC70A-TGU
Summary of Contents for DFI EC70A-TGU
- Page 1 Quick Installation Guide EC70A-TGU www.dfi.com Package Contents • 1 EC70A-TGU system unit • Remote switch cable (100cm) • Mounting screws for M.2 module • Rubber foot screws • Grounding screw © May 09, 2023 DFI Inc.
-
Page 2: Product Overview
Product Overview Front View *Default COM 1 (RS232*/RS422/RS485) Power Button (w/status LED) COM 2 (RS232*/RS422/RS485) HDD LED Antenna Hole COM 4 (RS232) Reset Button Quick Installation Guide | EC70A-TGU... - Page 3 Rear View SKU 1 SKU 2 SKU 3 *Default COM 3 (RS232*/8-bit DIO) USB 3.1 DC-in (9V ~36V) LAN 4 LAN 1 ~ 2 HDMI 1 ~ 2 LAN 3...
-
Page 4: Led Indication
LED Indication Status LED Suspend Mode LED Behavior Always ON Quick Blink (cycle 1 sec) Slow Blink (cycle>1 sec) S4, S5 HDD LED LED Behavior Status Blink Disk access activity HDD present or HDD not present Removing the Chassis Cover Please read and follow the instructions below to open the system. -
Page 5: Installing The So-Dimm Module
Installing the SO-DIMM Module Before installing the memory module, please read and follow the safety cautions below. 1.Make sure the PC and all other peripheral devices connected to it has been powered down. 2.Disconnect all power cords and cables. 3.Locate the SO-DIMM socket on the system board. 4.Make sure the notch on memory card is aligned to the key on the socket. - Page 6 The clips snap automatically and abruptly to the retention notches of the card sounding a distinctive click, and lock the card in place. Inspect that the clip sits in the notch. If not, please pull the clips outward, release and remove the card, and mount it again. Step 4 Quick Installation Guide | EC70A-TGU...
- Page 7 COM 3 Jumper Setting Remove the 4 screws of the heat shield and put them in a safe place for later use. Remove the heat shield and the COM 3 jumper is readily accessible. Heat shield Assignment Assignment RS232 (default) 10-11 11-12 Assignment...
- Page 8 DIOA6 Pin9 DIOA7 DFI reserves the right to change the specifications at any time prior to the product's release. This QR may be based on the product’s revision. For more documentation and drivers, please visit the down- load page at www.dfi.com/downloadcenter, or via the QR codes to the right.